AEON-CC changelog Version 3.2.R3 (release): Fixes: - Fixed problem with tally lights on Grass Valley when connected via ethernet. - Fixed problem with Grass Valley ethernet cameras showing Connected when removing the cable. - Fixed color matrix control in unidirectional for Panasonic Studio Ethernet cameras. Version 3.2.R2 (release): Features: - Added support for Panasonic Ethernet Connection at the camera end. - Panasonic Ethernet settings are now exposed on the webpage of the camera control. Fixes: - Fixed a problem where bars could not be switched off in Panasonic ethernet unidirectional mode. Version 3.2.B1: Features: - Added support for ethernet connection at Panasonic Camera end. Version 3.1.R1: Features: - Added full support for Grass Valley C2IP interface via ethernet on the camera side. Fixes: - Device now notifies users to power cycle after certain operations. Version 3.0.RC5 (release candidate), Version 3.0.B5 (beta release): Features: - Exposed Camera Control parameters to configuration page and presets - Added save to file and load from file capabilities for the presets Fixes: - Corrected a problem with video 4K60p setting Version 3.0.B3 (beta release): Fixes: - Corrected a problem with updating the RF settings of the device - Updated the intialised defaults to set the modulation mode to DVB-T Version 3.0.B2 (beta release): Fixes: - Exposed Ultra Low delay mode under Advanced > User Preset > Video Version 3.0.B1 (beta release): Features: - New webpage to allow configuration of the modulator and encoder remotely. - Added an option on the front panel to allow for reseting the whole unit to defaults. - User Presets: * Preset settings can be set via the webpage and stored in the device * Presets can be recalled and applied via the front panel or the webpage * The active configuration can be stored in the unit as a set of presets Fixes: - Modulator module would not correctly reset to default values when requesting a reset - Branding of the startup screen would change after a camera control reset.